Pony Bead Pattern Maker

Upload a picture and get a pony bead pattern for ladder stitch, brick stitch, peyote, a kandi cuff or an X cuff. Every pattern goes through that stitch's build check and a step-by-step simulation, so you can actually string the result, not just look at it.

Pattern

Build check

    Build simulator

    What you'll need

    Step by step

    Tick steps off as you go. Tap a step to see it in the simulator.

      How the build checks work

      Each stitch can only make certain shapes, so every pattern is checked against the rules for its stitch. Repairs only ever add beads (outlined in red), never remove parts of your design. The finished pattern is then re-checked from scratch and stepped through in the simulator.

      Ladder stitch (one cord folded in half, both ends cross through each row):

      • Each row is one unbroken run, because both cord ends go through every bead.
      • No empty rows, and each row overlaps the row above, so nothing hangs off bare cord.
      • Edges shift by no more than your limit per row, which avoids long, floppy cord diagonals.

      Brick stitch (beads sit sideways, offset by half a bead, each one hanging on the thread between two beads of the previous row):

      • You start with the widest row as a ladder-stitched base, then work up, then flip and work down.
      • Moving away from the base, a row can stick out at most half a bead past the row before it (an increase). There's no thread to hang a bead on any further out. Stepping in can be any amount.
      • Any row you build onto needs at least 2 beads, so there's a thread bridge between them.

      Peyote (columns offset by half a bead; each pass adds a bead into every other column):

      • The panel is a solid rectangle. Empty spots become background beads.
      • It has an even number of columns, so each row turns the simple way.

      Kandi cuff / multi-stitch (peyote worked in the round):

      • The base bracelet holds rows 1 and 2 and must have an even bead count.
      • Your picture is centered on the front of the cuff, with background beads the rest of the way around.
      • The cuff's circumference is checked against a normal wrist size.

      X cuff, single band (one band of the base loop, with an arc over each connector):

      • The base loop is 2 filler beads, then 1 connector, repeated around. Your picture sits on the connectors.
      • Each connector gets an arc: 3 new beads (connector, filler, connector) threaded from it to the next connector.
      • Every connector has an arc on each side, so the thread crosses at every connector.